Part# TTP0300075PL
Carbon Steel, Plain
Supplied by Stanlok
Nut is not included
#3 X 3/4 In. Taper Pin Size
0.201 In. Small End Diameter
0.217 In. Large End Diameter
1 In. Total Length with 0.75 In. Useable Length
10-32 Thread Size
✅ RoHS Compliant ✅ REACH Compliant
Carbon Steel, Plain
Supplied by Stanlok
Nut is not included
#3 X 3/4 In. Taper Pin Size
0.201 In. Small End Diameter
0.217 In. Large End Diameter
1 In. Total Length with 0.75 In. Useable Length
10-32 Thread Size
✅ RoHS Compliant ✅ REACH Compliant
Threaded taper pins are used whenever a taper pin has to be removed from the driven side. Threaded taper pins are 0.002" smaller on the large end diameter to allow the pin to be inserted approximately 3/32" deper int the taper-reamed hole. The lare end of the pin is recessed below the surface which allows the nut to bear on the surface when tightened to pull the pin out.