• Home
  • SH-168ST ZD, 1-11/16 in. Dia External Ring, 0.062 In. Thick Carbon Steel Zinc Dich

SH-168ST ZD, 1-11/16 in. Dia External Ring, 0.062 In. Thick Carbon Steel Zinc Dich

SKU: SH-168ST ZD
(0) No Reviews yet

1358 In Stock

1358 In Stock

(*) Minimum Quantity: 25

Part# SH-168ST ZD

Carbon Steel, Zinc Dichromate Yellow
Manufactured by Rotor Clip

1.688 In. Shaft Diameter, Basic External Ring
1.56 In. Free Inside Diameter
0.062 In. Thick
0.125 In. Hole Diameter

1.589 In. Groove Diameter
0.068 In. Groove Width
0.049 In. Groove Depth

WARNING: This product can expose you to chemicals including Chromium (hexavalent compounds) which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Basic external retaining ring in carbon steel, zinc yellow plated. Tapered section retaining rings decrease symmetrically from the center to the free ends, remaining circular when contracted or expanded within the limits of normal use. This assures contact with the groove along the entire periphery of the ring. These rings may be installed axially (horizontally along the center point of an axis) or radially (externally along the radius of a circle). Axially assembled retaining rings are installed into machined grooves in housings/bores (internal) or on shafts (external). These rings are manufactured with lug holes—small holes in the lugs of both axial internal and external retaining rings—that are used to install/remove them, using pliers designed for this purpose.

Ratings & Reviews

No reviews available

Be the first to Write a Review